Новости:

Форум снова в строю, но с регистрацией и входом со старым паролем пока проблемы.

Главное меню

BeerSmith 3 (2019) - обзор, уроки

Автор celestialvoice, 09.06.2018, 12:27

« назад - далее »

Zver

Backsweeten
"Подслащение" сбродившего напитка (после остановки сбраживания пастеризацией или химически) путем добавления меда или сиропа:

[attach]5187[/attach]

Zver

Sulfite Tool
Расчет сульфитации меда/вина

[attach]5196[/attach]

Zver

Adjust Gravity
Корректировка плотности путем разбавления водой либо добавления солодового экстракта

[attach]5197[/attach]

Zver

В новом BS3 появилась опция расчета добавки солей без использования мела:

[attach]5188[/attach]

Zver

Еще раз про "настройку" оборудования:

A new brewer must take as many measurements as possible over at least 5 brews to learn their equipment. Here are four that you can do on each brew. Each reading helps confirm the others.

1. Mash Efficiency: Measure volume and gravity at the start of boil. (Ensure wort is well-mixed. Cover your hot wort sample in wrap to avoid evaporation while it cools).

2. Post-Boil Efficiency: As above but taken at the end of the boil. This should on average be very close to your Mash Efficiency. The post-boil volume figure you collect here will also enable you to calculate and confirm your boil-off.

3. Brewhouse Efficiency: Measure volume and gravity of wort in the fermenter.

4. Loss to Trub and Chiller: Measure the volume that remains in your kettle (and chiller if counter-flow) after transfer to fermenter. Typing this and your Brewhouse Efficiency into the attached spreadsheet, online tool or the actual fields of BeerSmith2 will help confirm your Mash Efficiency.

Doing all these measurements gives you practice at taking readings and will make you realise faster that variances between readings and single brews are not uncommon. At the end of these five brews you will also have excellent base figures from which to create your own equipment profile.

http://www.beersmith.com/forum/index.php/topic,5140.0.html

Zver

Появился русификатор для BeerSmith 3. Необходимо распаковать файл и скопировать в папку с установленной программой.