Нулевая генерация означает, что на дрожжах нет рубцов от деления.
Имел редкую возможность варить почти два годы условно одинаковое пиво на Ноттингемах и S-04. Сейчас я могу сказать - это ужасно. Отсутствие ароматики и плохое осветление - теперь это мои друзья. За всё это время я не смог добиться приемлемой прозрачности пива в 70% варок.
Однако прошлым летом я повторно использовал дрожжи и результат брожения был полностью иным. Ароматика была заметно лучше, флокуляция тоже. Это в целом общеизвестный факт, однако...
На сайте ProBrewer есть интересный опрос по количество генераций, которые люди используют на пивоварне:
Меньше 10 генераций 42%
10-15 27%
16-20 9%
21-25 4%
Больше 25 17%
Я к сожалению отношусь к первой категории, на всех моих пивоварнях, разве что кроме Черепахи, было рисковано делать более 3-х генераций. Однако сейчас в Тоннах я добился хорошей чистоты и похоже пора начинать повторно использовать дрожжи.
ЦитироватьUntil there is a problem there is not a problem. Problem is subjective! I work in a commercial brewery and I've pitched the same yeast over 200 times before renewing. The reason why it was renewed was it just started to struggle to fully attenuate over the required timespan. Leading up to that decision we were rousing, increasing the temperate, slightly increasing the pitch rate etc to get the beer finished in time. Probably could have still used it, we make a lot of different products and if everything stays pretty much the same you don't get quite the variation over time.
What problems occur? Your yeast can pick up contamination which is pretty much impossible to avoid. You then grow that contamination up alongside your regular yeast until it becomes a big enough contamination is cause quality issues within the desired shelf life. I used to think that one lactic will rapidly multiply to cause problems, but they kind of don't. A small amount are always present, but don't really take over, all the usual stuff keeps the population fairly suppressed even over many generations. Same with wild yeast. Nothing can compete with the pitch rates we use and cask beer is just ... drunk super quick. Under a microscope often find the odd lactic, not enough to cause a problem until 6-9 months.
Genetic drift is a thing, but also kind of not. Some traits are gone from the strains genome and aren't coming back. There is also this self selecting thing where a quantity of yeast will contain 50% of generation 0, 25% of generation 1, 12.5% of generation 2, 6.25% of generation 3, 3.125% of generation 4 and so on out until generation 6 where the numbers start to get so small. Yeast leaves a scar on its cell wall each time it buds and out past generation 6 the yeast has such a damaged cell wall it struggles to correctly transport things into and out of the cell walls. This means a population eventually becomes self limiting in regard to number of generations. Each time you pitch most of the cells are from the first few generations and they produce the majority of the next generations so drift isn't as bad as you think.
People toss yeast at generation 6 because of the cell membrane thing, not because it has genetically drifted by this point. As long as you keep your culture clean you can theoretically use it indefinitely, until you have problems, then you have problems.
Anyway. What else? You can acid wash yeast occasionally. pH 2.2 for 20m with phosphoric acid is standard. We do cell counts and viability on every beer on package, but not on pitch unless we are investigating problems. Our process is the same every single time and we know how many cells are in 1g of slurry, what the viability is going to be based on storage (tends to lose 5% per day under barm ale, 2-3% under distilled water @ 4C) and so on.
If I've been using an interesting yeast I'll run off slurry into a sanitised drum and top off with distilled water. I've got a bunch of these hanging around the brewery. Occasionally I want some for something and I think ... man this is 2 months old, the viability is shot, but more often than not it isn't that bad from the fluid layer, the stuff at the bottom is dead, but a slight swirl, take off some liquid, typically 100x10^6 cells per ml at 70-80% viability, usually put 100ml into a flask with 2L of fresh wort and spin it up overnight if I want it for a homebrew.
[/size]
Странно. Я думал, что со временем аттенюация растет. Или это касается (и связанно) с повышенной контаминацией?
О чем вопрос конкретно? При повторном использовании без удаления старых клеток постепенно ухудшается аттенюация и флокуляция. На первых 5-6 генерациях это не заметно. Поэтому без всяких проблем эти генерации можно использовать, если нет проблем с заражением. А они часто есть :)
Однако раньше я не припомню чтобы шла речь о ненужности аэрации для сухих дрожжей... А сейчас вот как:
ЦитироватьInoculate without delay into cooled wort in the fermenter. LalBrewTM New England yeast has been conditioned to survive rehydration. The yeast contains an adequate reserve of carbohydrates and unsaturated fatty acids to achieve active growth. It is unnecessary to aerate wort upon first use.
Ну и вот они 30-35С:
ЦитироватьSprinkle the yeast on the surface of 10 times its weight in clean, sterilized water at 30-35°C (86-95F). Do not use wort, or distilled or reverse osmosis water, as loss in viability may result. Stir gently, leave undisturbed for 15 minutes, then stir to suspend yeast completely. Leave it to rest for 5 more minutes at 30-35°C.
Цитата: evgen, post: 47814, member: 1О чем вопрос конкретно?
Цитата: Zver, post: 47762, member: 5276Странно. Я думал, что со временем аттенюация растет.
Скажите, а на производствах аэрируют сусло?
Что-то я нигде не встречал такой информации.
Более того, считается, что аэрация емкости с дрожжевой культурой намного эффективнее аэрации сусла.
На совсем приличном производстве есть дрожжанки и поддерживается непрерывная культура дрожжей, да, ничего аэрировать не нужно. А так - везде. Ты собираешь дрожжи, они густые, проаэрировать их невозможно. Аэрируется сусло после теплообменника.